Improvement of the slurry blender automated control system used during hydraulic fracturing of a formation
UDC: 622.04
DOI: 10.33285/2782-604X-2023-3(596)-45-52
Authors:
ANDRIYANOV ALEKSEY M.
1,
SOSNIN ARTUR V.2
1 Tyumen Industrial University, Tyumen, Russia
2 JV "MeKaMineft", Megion, Russia
Keywords: automated process control system, hydraulic fracturing of a formation, slurry blender, controller, automatic control system
Annotation:
The article is devoted to the automation of one of the methods, applied when intensifying the work of oil, gas condensate, gas wells and increasing injection wells the injectivity – hydraulic fracturing (HF). After hydraulic fracturing, the well flow rate usually increases sharply. The method makes it possible to "revive" idle wells, where oil and gas production by traditional methods is no longer possible or unprofitable. In addition, the method is currently used to develop new oil formations, the extraction of oil from which by traditional methods is unprofitable due to low production rates. Hydraulic fracturing is also used for the production of shale gas and compacted sandstone gas. The directions for improving the automation system of installations used in hydraulic fracturing are considered.
Bibliography:
1. Muzipov Kh.N. Intensifikatsiya pritokov nefti s pomoshch'yu zvukovykh voln: dis. … kand. tekhn. nauk: 25.00.17. – Tyumen', 2005. – 125 s.
2. Andriyanov P.A., Bur M., Andriyanov A.M. Avtomatizatsiya protsessov bureniya v sistemakh verkhnego privoda firmy "Bentek" // Avtomatizatsiya, telemekhanizatsiya i svyaz' v neftyanoy promyshlennosti. – 2019. – № 5(550). – S. 21–26. – DOI: 10.33285/0132-2222-2019-5(550)-21-26
3. Andriyanov A.M., Andriyanov P.A., Bur M. Drilling automation based on rigs equipped with the top drive system // IOP Conf. Series: Earth and Environmental Science. – 2018. – Vol. 181. Int. Academic Conf. "The state, trends and problems of development of the oil and gas potential of Western Siberia", Sept. 28–29, 2017, Tyumen, Russia. – DOI: 10.1088/1755-1315/181/1/012002
4. Rukovodstvo po ekspluatatsii i tekhnicheskomu obsluzhivaniyu peskosmesitel'noy ustanovki firmy "C.A.T. GmbH" modeli 0204-05. – URL: https://goes-well.com/ru/datasheet-download-russian/
5. Siemens S7-300. Programmiruemyy kontroller. – URL: https://www.siemens-pro.ru/components/s7-300.htm
6. Teoriya avtomaticheskogo upravleniya: ucheb. posobie / S.E. Dushin, N.S. Zotov, D.Kh. Imaev, N.N. Kuz'min; pod red. V.B. Yakovleva. – SPb.: SPbGETU LETI, 2005. – 567 s.
7. Besekerskiy A.V., Popov E.P. Teoriya sistem avtomati-cheskogo upravleniya. – 4-e izd., pererab. i dop. – SPb.: Professiya, 2004. – 747 s.
Back to issue