Scientific and technical journal
«Equipment and technologies for oil and gas complex»
ISSN 1999-6934
№ 6(132), December 2022
MACHINERY AND EQUIPMENT
Pilot tests of an equipment set for a resonant single-wire power transmission system
5-13
Results of pilot testing of vacuum reclosers at the JSC "Orenburgneft" facilities
14-17
Features of changing the impact toughness of seamless hot worked pipes from 09G2S steel
18-23
Integrated engineering solutions for improving the operation of a multi-stream switching manifold
24-29
Estimation of holding strength of laser-welded heat-exchange tubes in the tube sheet
30-34
NEW METHODS AND TECHNOLOGIES
Joint preparation of products of oil and gas condensate deposits from the Urengoyskoye oil and gas condensate field
35-39
CONSTRUCTION OF OIL AND GAS WELLS
Determination of the optimal direction of a horizontal shaft drilling trajectory according to the vector of the primary horizontal stress to increase the efficiency of a formation hydraulic fracturing
40-48
The use of composite pipes as an alternative to casing pipes made of steel alloys
49-55
DEVELOPMENT OF OIL AND GAS FIELDS
Increase of the efficiency of the reservoir pressure maintenance system by the application of the radial reservoir opening on the example of the Western Siberia field
56-62
Fluid selection for cyclic injection into the Upper Jurassic deposits using a downhole heater to enhance oil recovery
63-68
Analysis of the field reservoir pressure maintenance system being implemented based on the methodology for identifying unproductive water injection
69-74
Comparison of the technological properties of polymer flooding reagents on the basis of a set of laboratory studies
75-78
The use of devices for in-line treatment of gas-liquid flows to optimize oil and gas gathering systems
79-89
The possibility of using controlled multifrequent acoustic fields for gas condensate stabilization
90-93
PIPELINE TRANSPORT
Analysis of technical-economic aspects of gas pipelines diagnostics and repair
94-98
A system for emptying compressor stations equipment based on a jet ejector
99-103